This repo was merged into the main Pwnagotchi repository.
Image builder for Pwnagotchi based on pi-gen.
Produces ready-to-flash .img.xz images for both 32-bit (Pi Zero W) and 64-bit (Pi Zero 2W, Pi 3, Pi 4, Pi 5) hardware.
~20GB free disk space and the following packages:
sudo apt-get install -y \
git quilt qemu-user-static debootstrap zerofree \
libarchive-tools curl pigz arch-test qemu-utils \
qemu-system-arm qemu-user \
gcc-aarch64-linux-gnu gcc-arm-linux-gnueabihf# Clone the repo
git clone https://github.com/jayofelony/pwn-gen
cd pwn-gen
# 64-bit (Pi Zero 2W, Pi 3, Pi 4, Pi 5)
make 64bit
# 32-bit (original Pi Zero W)
make 32bitFinished images are placed in ~/images/.
# Install Docker
sudo apt-get install -y docker.io
sudo usermod -aG docker $USER
# Log out and back in after this
# 64-bit
./pi-gen-64bit/build-docker.sh -c config-64bit
# 32-bit
./pi-gen-32bit/build-docker.sh -c config-32bit| Device | Image |
|---|---|
| Pi Zero W (original) | 32-bit |
| Pi Zero 2W | 64-bit |
| Pi 3 | 64-bit |
| Pi 4 | 64-bit |
| Pi 5 | 64-bit |
Before building, check the config files:
config-64bit— settings for the 64-bit buildconfig-32bit— settings for the 32-bit build
You can override build paths at the command line if needed:
make 64bit BUILD_USER=myuser
make 64bit IMAGE_DIR=/mnt/storage/imagesFlash the resulting .img.xz from ~/images/ using Raspberry Pi Imager or dd:
# Find your SD card device first - be careful to get the right one!
lsblk
# Flash with dd (replace sdX with your actual device)
xzcat ~/images/your-image.img.xz | sudo dd of=/dev/sdX bs=4M status=progress
syncAfter flashing, use PwnConfig to generate your config.toml, then copy it to /etc/pwnagotchi/ on the boot partition before first boot.
